Use the GigaProbes (Patent Pending) SMA Signal to Signal Pitch Calibration Wrench to set the probe tips to .8 mm, 1 mm and 1.27 mm pitch. Use the 110mm precision Tweezers Accessory to custom set the probe pitch. The wrench end is used to tighten the SMA cables to the Probe’s twin SMA connectors.
Pitch Calibration and SMA Wrench (side 2)
The GigaProbes(tm) S-S calibration wrench is used to set the probes pitch and plainerize the two probes so they land on the surface at the same time. The end of the wrench is used to tighten the SMA Cable to the probe and to the TDR.
